Filter
Top Products
Amplifier
Right
Left
First
remove
jumpers
First
remove
jumpers
Pre-amp
+
-
Speaker Connector Options
Bare Wire Connection Banana Plug Connection Spade Plug Connection
Loosen 1/2" (13mm) hex nut.
Insert wire through hole and
tighten nut. Takes wire sizes up
to 8 gauge.
Insert banana plug into the top
of the hex nut. Ensure the hex
nuts are tightened.
Loosen hex nut and lift
moveable washer to expose the
top of the jumper strap. A
1/4"(6mm) or 5/16"(8mm) spade
will fit on the narrower section of
the post. Lower the washer and
tighten the hex nut.
WOO
FER
WOO
FER
W
OO
FE
R
W
OO
FE
R
W
OOFE
R
W
OOFE
R
½” (13mm)
Hex Nut
Movable
Washer
Jumper Strap
Bi-Wiring and Bi-Amping Options
All PSB Platinum Series speakers can be bi-wired (separate cables to the separated woofers and midrange/tweeters from
the same amplifier) and bi-amped (separate amplifiers). With single cable inputs, the jumper straps must be in place and
both sets of terminals tightened firmly. Before bi-wiring or bi-amping, ALWAYS remove the metal jumper straps that
connect the two sets of
binding posts on the
speaker. Loosen ½”
(13mm) hex nuts and lift
moveable washers to
remove the jumper strap.
With bi-amp hookup
you must use either
identical amplifiers or
amplifiers adjusted to
have the same voltage
gain. Consult your PSB
dealer or our Web site
for further information.
Bi-Wire Connections
7