PSB Speakers CW50R Speaker User Manual


  Open as PDF
of 2
 
• 5-1/4” woofer with stiff fi berglass textured polypropylene
cone, higher cone mass and enhanced motor strength to
optimize it to a restricted enclosure volume
• Low resonance 3/4 inch pivoting tweeter
• High power drivers and crossover for long term reliability
• Performance Enclosure and new construction bracket
available
Frequency Range (-6dB): 65-20,000Hz
Recommended Power: 20-60 Watts
Impedance (Nominal): 8 Ohms
Sensitivity (2.83V @1m) 86dB SPL
Drivers: 5-1/4” Woofer
3/4” Dome Tweeter
Overall Dimensions (Diameter x D): 7-13/16 diameter x 2-15/16”
Cut-out Dimensions (Diameter): 6-1/2”
CW50R - 5.25” Coaxial Speaker System
ww w.p sbs pe ake rs .co m
1 8 8 8 7 7 2 0 0 0 0
• Optimal spacing between speakers should
approximately equal the distance from the
listening area to the wall.
• Make a small exploratory hole and check
for obstructions in wall cavity before cutting
mounting hole.
• Use the mounting template provided to cut
the right sized mounting hole.
• Lightly fi ll wall cavity with fi berglass 2 feet on
either side of the system. Use standard 4”
fi berglass split to half thickness. Use 1” thick
fi berglass behind system. stem.
• Adjust electric screwdrivers to appropriate
torque. Tighten mounting screws fi rmly but
do not over tighten!
• Angle the tweeter inward towards the
listening area.
• See manual for more installation hints.
Installation Notes
PSB Speakers reserves the right to change specifications or features without notice.
© 2006 PSB Speakers, a division of Lenbrook Industries Limited.
PSB is a registered trademark of Lenbrook Industries Limited. Printed in Canada 08/06. All rights reserved.
No part of this publication may be reproduced, stored or transmitted in any form whatsoever without the written permission of PSB Speakers
823 CW50R data.
To Reach US Customer Service dial 1 888 772 0000 ext 4445 or 4342
6-1/2"
165mm
2-15/16"
75mm
7-13/16"
198mm
 previous