Filter
Top Products
• Fire Rated to UL 2043 and UL1480
• Fully enclosed with steel back can
• 6 ½” (165mm) polypropylene coned woofer
• ¾” (19mm) aimable soft dome tweeter
• direct input plus 3 steps of 70/100 volt input transformer
Frequency Range (-6dB): 80-20,000Hz
Recommended Power: 20-100 Watts
Impedance: 8 Ohms
Sensitivity (1W (2.83V) @1m)
Anechoic Chamber: 90dB SPL
Typical Listening Room: 92dB SPL
Drivers: 6 1/2” Woofer,
3/4” Dome Tweeter
Overall Dimensions (Diam. x D):
9-7/8” Diameter (250mm) x 7-3/4” (195mm)
Cut-out Dimensions: 8-7/8” Diameter (226mm)
CW170FR Fire Rated In-Ceiling System
www.psbspeakers.com
1 888 772 0000
• Make small exploratory hole and check for
obstruction in ceiling cavity before cutting
mounting hole.
• Trace carefully around the provided cutout
template at the desired speaker location.
• Cleanly cut the hole to the circle just traced
• For preconstruction and ceiling tile
installations use the preconstruction brackets
provided (see manual for details).
• Connect bare wires via the screw terminal
connector under the protective rear cover
plate.
• For most installations set the 70/100Volt
switch to the 8ohm (bypass) position.
• With 70/100Volt systems and multiple
speakers, set level of each speaker as
desired via other 3 positions (don’t use
position marked with dot).
• Aim the tweeter towards the center of the
listening area.
• See manual for more installation hints.
Installation Notes
PSB Speakers reserves the right to change specifications or features without notice.
© 2007 PSB Speakers, a division of Lenbrook Industries Limited.
PSB is a registered trademark of Lenbrook Industries Limited. Printed in Canada 08/07. All rights reserved.
No part of this publication may be reproduced, stored or transmitted in any form whatsoever without the written permission of PSB Speakers.
876 170FR Data
To Reach US Customer Service dial 1 888 772 0000 ext 4445 or 4342
9-7/8”
(250mm)
7-3/4”
(195mm)
8-7/8”
(226mm)