PSB Speakers CW160S Speaker User Manual


  Open as PDF
of 2
 
75v;MM=
v;=
v;MM=
+/-30˚
90˚
90˚
• 6 1/2” woofer and 3/4” tweeter
• Unique high-frequency, constant directivity SonicGuide™
gimbals to provide a focused, even response both on
and off axis
• SonicGuide™ can be tilted 30° left or right and the whole
assembly turned through 180 degrees
• Performance Enclosure and NCBs available
• Midrange and tweeter switches allow for 3dB response
adjustments
Frequency Range (-6dB): 45-21,000Hz
Recommended Power: 20-100 Watts
Impedance: 8 Ohms
Sensitivity (1W (2.83V) @1m)
Anechoic Chamber: 87dB SPL
Typical Listening Room: 89dB SPL
Drivers: 6” Woofer
3/4” Dome Tweeter
Overall Dimensions (Diameter x D): 9 1/2 diameter x 3 3/4”
Cut-out Dimensions (Diameter): 8 3/4”
Overall Dimensions (W x H x D): 9 1/2 x 9 1/2 x 3 3/4”
Cut-out Dimensions (W x H): 8 3/4 X 8 3/4”
CW160R / CW160S 6” Coaxial Speaker System
www.psbspeakers.com
1 888 772 0000
• Try to install the systems at a height between
seated and standing ear level.
• Distance between left and right speakers
should approximately equal the distance
from the listening area to the wall or ceiling.
• Make small exploratory hole and check for
obstructions in wall cavity before cutting
mounting hole.
• Use template provided and carefully mark
and cut mounting hole.
• Lightly ll wall cavity with berglass for 2 feet
above and below system (CW160S). Use
standard 4” berglass split to half thickness.
Use 1” thick berglass behind system.
• Adjust electric screwdrivers to appropriate
torque. Tighten 4 mounting screws rmly but
do not over tighten!
• SonicGuide™ tweeter can be rotated +/- 90
degrees, then +/- 30 degrees on its axis.
• Aim tweeter toward center of listening area.
• Switches give subtle balance adjustments
for midrange and treble. Set to suit room
acoustics and personal taste.
• See manual for more installation hints.
Installation Notes
PSB Speakers reserves the right to change specifications or features without notice.
© 2004 PSB Speakers, a division of Lenbrook Industries Limited.
PSB is a registered trademark of Lenbrook Industries Limited. Printed in Canada 10/04. All rights reserved.
No part of this publication may be reproduced, stored or transmitted in any form whatsoever without the written permission of PSB Speakers
871 CW160 data.
To Reach US Customer Service dial 1 888 772 0000 ext 4445 or 4342
 previous