Filter
Top Products
10
LISTENING TO A PROGRAM SOURCE
Operations
Operate the selected component for
playback.
4
Adjust the volume to a comfortable lis-
tening level.
5
Then the corresponding speaker indica-
tion(“SPK A(or/and) B” is displayed and the
sound can be heard from the speakers con-
nected to the selected speaker terminals.
when ON is selected, the "SPEAKER A (or/
and) B" indicator lights.
When using the headphones for private listen-
ing, press the corresponding SPEAKER button
to switch off both A and B speakers.
Turn the power on.
1
Switch the desired speakers on.
2
Each time the FM/AM button on the front panel or
the TUNER button on the remote control is
pressed, the band is changed to AM or FM.
Select the desired input source.
3
When the POWER button on the remote control is
pressed, this unit is turned on to enter the operat-
ing mode.
In the standby mode, if an INPUT SELECTOR but-
ton is pressed, the unit is turned on automatically
and the desired input is selected.
In the operating mode, when the POWER button
on the remote control is pressed, then it enters the
standby mode.
Before operation
• This unit enters the standby mode.
The lighting of STANDBY indicator means that the receiver is not
disconnected from the AC mains and a small amount of current is
retained to support the memorized contents and operation readiness.
•To switch the power off, push the POWER switch again. Then the
power is cut off and the STANDBY indicator goes off.
Push the POWER switch