Filter
Top Products
We want to thank you for choosing an amplifier from Proson. We hope that
it will bring you many hours of pleasure. Our amplifiers are suitable for both
HiFi as well as Home Theatre.
This amplifier has a wide field of application, we describe the most com-
mon ways to use it.
Using the amplifier as a subwoofer amplifier in Bi-Wiring:
1. Make sure that the amplifier is turned off.
2. Remove the metal tin-plates that are placed on the terminal on the
speaker.
3. Tweeter/midrange terminal is connected to the receiver.
4. Use a speaker cable to connect the tweeter/midrange terminal on
the speaker to “Speaker Level Input” L and R on the amplifier.
5. Use a speaker cable between the bass terminal on the speaker to
“Speaker Output” on the amplifier.
6. Make sure that the phase is correct, that you have connected + to
+ and – to -.
7. Turn on the amplifier and the receiver.
Using the amplifier as a subwoofer amplifier:
(Using a RCA cable)
1. Make sure that the amplifier and the receiver is turned off.
2. Use a RCA-cable from “Sub Out” on the receiver to “Line In” on the
amplifier.
3. Connect the subwoofer to “Speaker Output” on the amplifier.
4. Make sure that the switch is turned to “Low Pass”.
5. Make sure that the phase is correct, that you have connected + to
+ and – to -.
6. Turn on the amplifier and the receiver.
(Using speaker cables)
1. Make sure that the amplifier and the receiver is turned off.
2. Connect a speaker cable to Speaker Output on the receiver, R
(Right) to “Speaker Level Input R” on the amplifier.
3. Connect a speaker cable to Speaker Output on the receiver,
L(Left) to “Speaker Level Input L) on the amplifier.
4. Connect the subwoofer to “Speaker Output” on the amplifier.
5. Make sure that the switch on the amplifier is turned to “Low Pass”.
6. Make sure that the phase is correct, that you have connected + to
+ and – to -.
7. Turn on the amplifier and the receiver.
Use the amplifier as a full register amplifier
(Using RCA cables)
1. Make sure that the amplifier and the receiver is turned off.
2. Connect a RCA cable from “Pre Out” on the receiver to “Line In”
on the amplifier.
3. Connect a speaker cable from “Speaker Output” on the amplifier
to the speaker.
4. Make sure that the switch is turned to “Full”
5. Make sure that the phase is correct, that you have connected +
to + and – to -.
6. Turn on the amplifier and the receiver.
(Using speaker cables)
1. Make sure that the amplifier and the receiver is turned off.
2. Connect a speaker cable from Speaker Output Left and Right on
the receiver to “Speaker Level input R/L” on the amplifier.
3. Connect a speaker cable from “Speaker Output” on the amplifier
to the speaker.
4. Make sure that the switch is turned to “Full”
5. Make sure that the phase is correct, that you have connected +
to + and – to -.
6. Turn on the amplifier and the receiver
Circuit breaker
ON-mode - Green light
STAND BY-mode - Red light
OFF-mode - No light
2
3