Filter
Top Products
12
NON-POLAR
CAPACITOR
INDUCTOR
(COIL)
L E G E N D
Left
Mid / Tweeter
4 Ohm
(2 Ohm Minimum)
Mono Woofer
8 Ohm
(4 Ohm Minimum)
Right
Mid / Tweeter
4 Ohm
(2 Ohm Minimum)
¹F100
¹F100
CAUTION! In Tri- mode operation, the amplifier must see a 2 Ohm load or higher for the
stereo satellites and no lower than 4 Ohms for the subwoofer(s).
Any lower than the above mentioned impedance will cause internal damage
to the amplifier.
SPEAKER CONNECTIONS (TRI-MODE)
All 2 channel amplifiers are capable of running both in Mono & Stereo mode. This feature
gives the amplifier the ability to run stereo satellites (midbass & tweeter) simultaneously
with a mono subwoofer.
These connections are more complicated because they require the use of passive crossover
networks (Not provided) to divide the frequencies to the speakers. We have included a sample
diagram for 4 Ohm connections. If you wish to use multiple speakers to achieve a lower
impedance and higher power, it is strongly recommended that you seek professional advice
from your Profile retailer before attempting to make these connections.
Please Note: In the Tri-mode configuration, the amplifier's built-in crossover must be set to
"FULL"(OFF) position.
4mH