Filter
Top Products
5
Warning
To prevent serious injury, electrical shock or fire:
• Do not operate with bottom plate removed.
• Keep away from rain and moisture.
• Always disconnect all cable connections to and from amplifier before changing fuses and/or
tubes.
• Do not replace fuses with any fuse other than the same type and rating as used by the factory.
• Do not replace tubes without reading instructions.
• Do not replace fuses or tubes if you have any doubt about your ability to do so. We accept no
responsibility for any personal or material damage due to incompetent use or users.
Package Contents
ProLogue Five Amplifier 1
Power Cord 1
This Owner's Manual 1
White Gloves 1 pair
Tube Complement 2 x KT-88
2 x 12AX7
2 x 12AU7
Main Fuse 1 x 5Amp slow blow 5 x 20mm for 100-120VAC or
1 x 3Amp slow blow 5 x 20mm for 200-240VAC
Plate Fuse 1 x 1Amp slow blow 5 x 20 mm
Initial Setup
• Carefully remove the ProLogue Five from its packaging. Use the white gloves to prevent
fingerprint smudges.
• Remove the tube cage by carefully pulling it up and away from the amplifier.
• Remove the protective foam surrounding the tubes.
• Tubes are already installed. Check that each tube is firmly seated in its socket. Use gloves.
• Replace cage back in its place if desired.
• Check to see the power switch is off (down).
• Connect your speaker wires: positive to positive; negative to negative. This unit is non-inverting.
• Plug the power cord into the wallsocket and into your amplifier.
• Switch the preamplifier on and wait for 1 minute to stabilize the circuit.
• Switch the poweramplifier on.
• The tubes will be warmed up and ready to use in about 30 seconds.
PrimaLuna® ProLogue Five