Filter
Top Products
5
O W N E R ’ S M A N U A L
P-1200
C O N N E C T I O N
No signal connection cable is provided with the P-1200 subwoofer since the type and length of cable is installation
specic. A shielded RCA type coaxial cable, a shielded two-conductor wire with RCA type connectors, or a
2-channel speaker cable is required for connection of the P-1200 to the audio system. Ensure sufcient length to
reach from the system source to the subwoofer’s line or speaker level input. If you are uncertain about the type
and length of wire to purchase after reading this section and the section on Placement then please contact your
dealer for assistance.
Before making any connections, ensure that power cord is disconnected or that the main power switch is switched
to the off position.
Input Signal: Follow the diagram on page 7 for connecting the subwoofer to your audio system. Use the option
that best suits your installation. WARNING: Use only one of the three options, (Do Not Combine Options).
The information below will aid in determining which option to use.
Note: The best performance can be achieved using the line level inputs ( or ) as opposed to
the speaker level inputs ( ).
!
RISQUE DE CHOC ELETRIQUE
NE PAS OUVRIR
1
2
3
4
5
6
78910
1
2
3
4
5
6
7
8
9
10
Power and Standby Mode Indicator – Off=No Power; Green=On; Red=Standby
Auto Power Mode Switch – Selects if amplier power is signal activated; On=Signal Sensing, Off=Bypassed (Amp ON)
Level Control – Adjusts output level of subwoofer
Phase Control – Adjusts relative alignment of output signal with respect to the input; 0°=In Phase, 180°=Out of Phase
Crossover Frequency Control – Adjusts low pass lter cutoff frequency
Crossover Bypass Switch – Selects if internal crossover (low pass lter) is active; Variable=Active, Bypass=Inactive
Line Level Input – Input connection for RCA Line Level signals from processor or preamp; Includes LFE & Sub signals
Speaker Level Input – Input connection for High Level signals from amplier
Power Input Receptacle and Fuse Holder – IEC 2-conductor 120V receptacle accepts supplied IEC power cord
Master (Main) Power Switch – Primary power; On=Power Enabled; OFF=Power disconnected from amplier circuit
OPTION 2
OPTION 3
OPTION 1
U.S. Patent #5,075,634 and
5,510,753 Patent Pending