Filter
Top Products
Control Panel Functions
1.Input Selection Switch
2.Master Volume Control
3.Subwoofer Level Control
The Subwoofer Level Control will increase or decrease the output level of the subwoofer pre-amp
output in relation to the Master Volume Control.
4.Graphic Equalizer Controls
The Graphic Equalizer Controls will increase or decrease the level of its corresponding frequency,
-18dB or +18dB. Turn the knob counter-clockwise (left) to decrease the level, clockwise (right) to
increase the level.
The Mater Volume Control can be used as a primary or secondary volume control for your audio
system. Generally, the source unit volume is set at a moderate level, then utilize the E.DZ's
Master Volume Control. The ring around the Mater Volume Control is a fader, to increase or
decrease the output levels between the front and rear outputs.
The Input Selection Switch controls which of the two inputs the E.DZ processes. Press the switch
in to accept the audio signal from your source unit through the CD input. Leave the switch out to
accept and process the audio signal from a secondary source unit or auxiliary device through the
AUX inputs.
Features
20dB Headroom Switching Power Supply
Built-in Low Noise Bi-FET Op-Amps
2 Selectable Balanced RCA Inputs w/ Input Gain
Front, Rear, & Subwoofer RCA Outputs
Four 18dB Front Bands; 125Hz, 500Hz, 3.5kHz, 12kHz
Three 18dB Rear Bands; 50Hz, 600Hz, 6.3kHz
Independent Subwoofer Level Control
Selectable Low-Pass Filter; 32Hz, 64Hz, 125Hz
Fader Control
Blue Backlit Control Knobs