Filter
Top Products
Instructions for Windows
Page 5
Instructions for Windows PC Users
Note: it is VERY IMPORTANT that you follow certain procedures
prior to connecting and configuring your PowerFile Changer.
These procedures include disabling the System Standby Mode,
loading the PowerFile MediaFinder software, and checking for
proper installation of the PowerFile drivers. These procedures
are outlined below.
Additionally, if your system does not have an OHCI-compliant 1394 PCI host adapter card
installed, you must install one before proceeding with the installation outlined in this
document.
To properly install and set up your PowerFile Changer, follow the steps below, in the order
presented.
Disable System Standby
Prior to installing the PowerFile MediaFinder software on a host PC, and turning on the
Changer for the first time, it is important that you follow the instructions below for disabling
the System Standby feature. Follow the appropriate section below, depending on whether the
Changer will be connected to a host system running Windows 98SE / Windows Me, or
Windows 2000.
Disabling System Standby feature - Windows 98SE / Windows Me
Go to Control Panel, and select Power Management
You will see the following window. Set System standby to "Never".