Filter
Top Products
4
PREP
ARING TO PAINT:
1. Separate the parts of the speaker. Remove
the brackets and bracket knobs. Remove
the grille by carefully hooking it with a
bent paper clip and pulling it gently away
from the cabinet [figure 4].
2. Mask off the binding posts on the back
of the speaker [figure 5], the end panels
and bracket knobs, and carefully mask off
the front of the speakers to protect the dri-
vers and baffles while painting [figure 6].
The grille features an engraved logo pod.
You can mask this off or paint right over it.
Get more information and exclusive accessories, visit www.polkaudio.com
FIGURE 4
Remove the grille using a paper clip.
Quite la rejilla con un sujetapapeles.
Retirez la grille en utilisant un trombone.
Entfernen Sie den Gitteraufsatz mit einer Büroklammer.
FIGURE 5
Mask the binding posts on the rear of the speaker.
Cubra con cinta de enmascarar los tornillos de presión ubicados en la parte de atrás del altavoz.
Masquez les bornes à l'arrière de l'enceinte.
Decken Sie die Anschlussklemmen auf der Rückseite des Lautsprechers ab.
FIGURE 6
Mask the drivers and baffles.
Cubra con cinta de enmascarar los excitadores y los bafles.
Masquez les haut-parleurs et les écrans acoustiques.
Decken Sie die Treiber und Resonanzwände ab.
P
AINTING YOUR ATRIUM AW
LOUDSPEAKERS
You will need:
• A spray can of primer paint (Krylon
Sandable Spray Primer #1318)
• A spray can of the paint of your choice.
Choose exterior grade paint if you
plan to use the speakers outdoors
• A paperclip or corkscrew (for removing
the paintable grille)
• Masking tape
• Paint mask (to cover unpaintable parts—
not included. To make an easy paint mask,
use the grille as a template and cut a mask
from heavy, nonporous Kraft paper.)