Filter
Top Products
Plantronics Savi User Guide 9
Powering Up the Headset
If the headset battery is charged and connected to the headset,
the headset is automatically on. The headset does not have an
on/off button.
Talk Time
With a single full charge, the Savi W410/W420 will provide up to
9 hours of talk time. Talk time will be reduced when operating in
wideband mode and/or if the headset is used consistently at a far
distance from the adapter.
Muting a Headset During A Call
Short press the dedicated mute button to toggle mute on/off. The
USB adaptor light will flash red when the headset is muted.
When mute is activated, you will hear three high tones. When
unmuted, you will hear three low tones.
After the Plantronics software is loaded, the mute tones can be
turned off by going to Start > Programs > Plantronics Control
Panel > Devices > Device Settings > Headset – Mute Tone.
5 Using Your Headset System
Placing, Answering, and Ending Calls with
Desk Phone
For your safety, do not use headset at high volumes for
extended periods of time. Doing so can cause hearing
loss. Always listen at moderate levels. For more information
on headsets and hearing visit:
plantronics.com/healthandsafety.
Phones with Handset Lifter or Electronic
Hookswitch
Phones without Handset Lifter or Electronic
Hookswitch
To place a call 1. Short press call control button on headset*
or short press base desk phone talk button
2. Dial number
1. Short press call control button on headset*
or short press base desk phone talk button
2. Remove handset from cradle**
3. Dial number
To answer a call 1. Short press call control button on headset
or short press base desk phone talk button
1. Short press call control button on headset or
short press base desk phone talk button
2. Remove handset from cradle**
To end a call 1. Short press call control button on headset
or short press base desk phone talk button
1. Short press call control button on headset or
short press base desk phone talk button
2. Return handset to cradle**
Indicator Light
Call Control Button
*Assumes use of supported softphone
**Assumes your default line is set to PC