Pioneer XV-DV88 CD Player User Manual


 
Additional information12
74
En
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
If the system is not operating normally due to external effects such as static electricity,
disconnect the power plug from the outlet and insert again to resume normal operation.
General
Problem Remedy
The power does not turn
on.
• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the system to shut off automatically.
No sound is output when
a function is selected.
• If you’re using the line input, make sure the component is connected
correctly (see
Connecting auxiliary components
on page 72).
• Press
MUTE
on the remote control to turn muting off.
• Adjust the
VOLUME
.
No image is output when
playing discs.
• Make sure the TV is connected correctly (see
Connecting to your TV
on
page 13).
• Reset the video output to interlace (see
Watching progressive scan video
from the component video outputs
on page 15).
No sound from surround
or center speakers.
• Refer to
Setting the channel levels
on page 60 to check speaker levels.
• Check that you haven’t selected the
STEREO
sound mode (see
Listening
in stereo
on page 40).
• Make sure the speakers are connected properly (see
Connecting the
speakers
on page 10).
Can’t operate the remote
control.
• Replace the batteries (see
Putting the batteries in the remote control
on
page 7).
• Operate within 7 m, 30° of the remote sensor on the front panel (see
Using the remote control
on page 8).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• You won’t be able to use the remote sensor of this unit with the
CONTROL IN
jack of this unit connected to the
CONTROL OUT
jack of
your plasma display. You can use the remote sensor of the plasma display
(even in standby) as long as the power isn’t switched off.
XV-DV88.book 74 ページ 2006年11月9日 木曜日 午後2時28分