Filter
Top Products
28
Preparations
Direct Function
The direct function is a useful feature which allows you keep the receiver in one function (for example, CD)
while putting the remote control in a different function. This could let you, for example, use the remote control
to set up and listen to a CD on the receiver and then use the remote control to rewind a tape in your VCR while
you continue to listen to your CD player.
When the DIRECT function is ON any MULTI CONTROL button you press will change the function of both the
receiver and the remote control. When you turn the DIRECT function OFF, you can operate the remote control
without affecting the receiver. Thus you could switch the remote control the VCR and operate that component
while the receiver plays a different component.
MULTI
CONTROL
DVD/LD TV/SAT VCR/DVR CD
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS CHANNEL
ATT
VOL
MENU
TOP
MENU
VOL
CH
2
DSP MODE
MIDNIGHT
5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL
EFFECT
ENTER
ENTER
FQ
FQ
ST ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
AUDIO/VIDEO PRE PROGRAMMED
TV CONTROL
FUNC
10 DISC
SIGNAL
SELECT
TEST
TONE
RECEIVER
TUNER
TV CONT
1234
1 ¡ 4 ¢
7 8 3
5678
90
‡
SOURCE CLASS MPX BAND
3
REMOTE
SET UP
2
Î
CH SELECT CH LEVEL
DSP TEST TONE
FL DIMMER
LOUDNESSFUNCTION SETUPMUTING
7
4
¢
2
ENTER
TV CONTROL
TV
DISC
MULTI CONTROL
DVD TV VCR CD-R
RCV CD TUN TVC
MIDNIGHT
SIGNAL SELECT EFFECT
+10
5.1CH ATT
123
456
789
0
VSX-D509S
To set a multi-function button to DIRECT OFF:
1
Press SETUP and hold for three seconds.
The LED will blink twice.
2
Press the MULTI CONTROL button which you
want to set to OFF.
3
Press 9, 8, then 3.
The LED blinks twice to indicate the button has been cleared.
To set a multi-function button to DIRECT ON:
1
Press SETUP and hold for three seconds.
The LED will blink twice.
2
Press the MULTI CONTROL button which you
want to set to ON.
3
Press 9, 8, then 2.
The LED blinks twice to indicate the button has been cleared.
TV CONT doesn’t have this feature and thus can’t use the DIRECT
FUNCTION.
VSX-D409
1
To turn the DIRECT function OFF (the default
setting is ON), press REMOTE SET UP and
number button 3 at the same time.
2
To turn the the DIRECT function ON (if you
have turned it off), press REMOTE SET UP and
number button 2 at the same time.
TV CONT doesn’t have this feature and thus can’t use the DIRECT
FUNCTION.
3
SET UP
2
9
8
MULTI CONTROL
memo
memo