Filter
Top Products
Additional information
12
73
En
Remote control
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
When playing certain discs,
none of the receiver’s format
indicators light.
• The audio format of the disc is not 5.1/6.1
channel.
• This is not a malfunction. Check the disc packaging for
details of the audio formats available on the disc.
When playing a disc, the
2
PL II
or
Neo:6
indicator lights
on the receiver.
• The input signal type is set to analog. • Set the receiver to
AUTO
or
DIGITAL
(see
Choosing the
input signal
on page 33).
• A two channel soundtrack is currently
playing.
• This is not a malfunction. Check the disc packaging for
details of the audio formats available on the disc.
• The soundtrack currently playing is
encoded using Dolby Surround.
• This is not a malfunction. Check the disc packaging for
details of the audio formats available on the disc.
During playback of a Surround
EX or DTS ES source on the
Extended AUTO
setting, the
EX
and
ES
indicators don’t light, or
the signal is not properly
processed.
•The source may be Dolby Surround EX / DTS
ES software, but it has no flag to indicate it is
6.1 compatible.
• Set to
Extended ON
(see
Using the surround back
channel (Extended mode)
on page 34) then switch to the
THX Surround EX or Standard EX listening mode (see
Listening in surround sound
on page 30).
Symptom
Cause Remedy
Symptom Cause Remedy
Cannot be remote controlled. • The remote control batteries have worn out. • Replace the batteries (see
Loading the batteries
on
page 7).
• Too far away or improper angle of operation. • Operate within 23 feet and a 30º angle of the remote
sensor on the front panel (see
Operating range of remote
control unit
on page 29).
• There is an obstacle between the receiver
and the remote control.
• Remove the obstacle or move to another place.
• Strong light such as fluorescent light is
shining onto the unit's remote control sensor.
• Avoid exposing the remote sensor on the front panel to
direct light.
• Something is plugged into the
CONTROL IN
jack.
• Unplug the cable from the
CONTROL IN
jack and use
remote normally (see
Operating other Pioneer components
on page 22).
• The IR receiver type is mismatched with the
setting.
• Disconnect the IR receiver from the rear panel or set to
the other IR receiver type (see
Multi Room Setup
on
page 67).
Other components can't be
operated with the system
remote.
• The preset code settings are wrong. • Input the correct preset code.
• The batteries wore out and the system
settings were cleared.
• Reset the proper system settings.
The SR cable is connected, but
the connected components can’t
be operated with the remote.
• The SR cable hasn't been connected
properly.
• Reinsert the SR cable, making sure it’s connected to the
right jack (see
Operating other Pioneer components
on
page 22).
• The rest of the component connections
have not been made.
• Make sure an analog connection has been made
between the units.
• The component you have hooked up is not a
Pioneer product.
• This feature only works with Pioneer products.
VSX_9100TX.book.fm 73 ページ ２００４年５月１９日 水曜日 午前９時５４分