Filter
Top Products
Other connections11
54
En
3 Press CLASS to select one of the three
classes then press
/
to select the channel
preset you want.
You can also use the number buttons to select
a preset.
• The default for all presets is
XM001
.
4 Press
ENTER
.
After pressing
ENTER
, the preset class and
number stop blinking and the receiver stores
the XM channel.
Listening to channel presets
You will need to have some presets stored to do
this.
1 Press CLASS to select the class in which
the channel is stored.
Press repeatedly to cycle through classes A, B
and C.
2 Press
/
to select the channel preset
you want.
• You can also use the number buttons on
the remote control to recall the channel
preset.
Connect & Play™, XM-Ready
®
and The Ultimate
Playlist are trademarks of XM Satellite Radio Inc.
©2005 XM Satellite Radio Inc. All rights reserved.
All other trademarks are the property of their
respective owners.
Second Zone speaker B setup
After selecting
Second Zone
in
Surround back
speaker setting
on page 34, you can use the
speakers connected to the (surround back) B
speaker terminals on the rear panel to listen to
stereo playback in another room. See
Switching the speaker system
below for the
listening options with this setup.
1 Connect a pair of speakers to the
surround back speaker terminals on the rear
panel.
Connect them the same way you connected
your speakers in
Connecting the speakers
on
page 19. Make sure to review
Hints on speaker
placement
on page 20 when placing the
speakers in another room.
2 Select ‘
Second Zone’
from the ‘
Surr Back
System’
menu.
See
Surround back speaker setting
on page 34
to do this.
Switching the speaker system
If you selected
Second Zone
in
Surround back
speaker setting
on page 34, three speaker
system settings are possible using the
SPEAKERS
button. If you selected
Normal (SB)
or
Front Bi-Amp
, the speaker system is fixed
as
SP
A
or
SP
AB
(respectively). The options
below are for the
Second Zone
setting only.
1
• Use the SPEAKERS button on the front
panel to select a speaker system setting.
Press repeatedly to choose a speaker system
option:
•
SP
A
– Sound is output from the speakers
connected to the A speaker terminals
(multichannel playback is possible).
•
SP
B
– Sound is output from the two
speakers connected to speaker system B
(only stereo playback is possible).
Note
1• The subwoofer output depends on the settings you made in
Speaker Setting
on page 40. However, if
SP
B
is selected above,
no sound is heard from the subwoofer (the LFE channel is not downmixed).
• Depending on the
Surround back speaker setting
on page 34 output from the surround back pre-out terminals may change.
• All speaker systems (except
Second Zone
connections) are switched off when headphones are connected.
MIDNIGHT/
LOUDNESS
QUICK
SETUP
SETUP
RETURN
TUNING/
STATION
TONE
ANALOG
ATT
SPEAKERS
TUNER
EDIT
DIMMER
MULTI JOG