Filter
Top Products
Other Settings
13
77
En
English
Français
Deutsch
Nederlands
Italiano
Español
1 Select DUAL MONO from the OTHER
setup menu.
2 Use
/
(cursor up/down) to choose the
setting that you want.
•
CH1
– Only channel 1 is played
•
CH2
– Only channel 2 is played
•
CH1 CH2
– Both channels are played
through the front speakers
3 When you're finished, press
RETURN
.
LFE Attenuator Setup
• Default setting:
ATT 0 dB
Some Dolby Digital and DTS audio sources
include ultra-low bass tones. Set the LFE
attenuator as necessary to prevent the ultra-
low bass tones from distorting the sound from
the speakers.
1 Select LFE ATT from the OTHER setup
menu.
2 Use
/
(cursor up/down) to choose the
setting that you want.
•
LFEAT 0
– No limiting (recommended
setting)
•
LFEAT 10
– 10dB of limiting
•
LFEAT **
– No sound from LFE channel
3 When you're finished, press
RETURN
.
SR+ Setup for Pioneer plasma
displays
VSX-815/915 model only
Make the following settings if you have
connected a Pioneer plasma display to this
receiver using an SR+ cable. Note that the
number of function settings available will
depend on the plasma display you’ve
connected.
See also
Using this receiver with a Pioneer
plasma display
on page 73 and
Using the SR+
mode with a Pioneer plasma display
on page 74.
1 Select ‘SR+’ from the OTHER setup menu.
2 Use
/
(cursor up/down) and
ENTER
to
select the ‘VOL C.’ setting you want.
•
VOL C. OFF
– The receiver does not control
the volume of the plasma display
•
VOL C. ON
– When the receiver is switched
to one of the inputs that use the plasma
display (
DVD/LD
, or another one of
functions below), the volume on the
plasma display is muted so only sound
from the receiver is heard.
3 Assign any input source connected to the
plasma display to the corresponding input
number.
Use
/
(cursor left/right) to select the
source (
DVD
,
TV
,
DVR
or
VDEO
), then
/
(cursor up/down) to select the input number.
This matches the receiver’s input source with a
numbered video input on the plasma display.
For example, assign
DVD:3
if you have
connected the your DVD video output to video
input 3 on the plasma display.
4 When you're finished, press
RETURN
.
VSX_815-915.book.fm 77 ページ ２００５年３月１日 火曜日 午前１０時２２分