Filter
Top Products
Listening to your system
06
33
En
English
Français
Deutsch
Nederlands
Italiano
Español
Using Midnight and Loudness
These features give you good sound at low
volume levels when listening to movie
(Midnight) or music (Loudness) sources.
• Press MIDNIGHT/LOUDNESS to switch
between MIDNIGHT, LOUDNESS, and OFF.
Enhancing dialog
• Default setting:
OFF
The Dialog Enhancement feature localizes
dialog in the center channel to make it stand
out from other background sounds in a TV or
movie soundtrack.
• Press DIALOG E (DIALOGUE
ENHANCEMENT) to switch dialog
enhancement on or off.
Using the tone controls
Depending on what you are listening to, you
may want to adjust the bass or treble using the
front panel tone control.
1 Press TONE to select the frequency you
want to adjust.
Press to switch between
BASS
and
TREBLE
.
2 Use the
MULTI JOG
dial to change the
amount of bass or treble as necessary.
Wait about five seconds for your changes to be
input automatically.
Using the Sound Retriever
When audio data is removed during the
compression process, sound quality often
suffers from an uneven sound image. The
Sound Retriever feature employs new DSP
technology that helps bring CD quality sound
back to compressed 2-channel audio by
restoring sound pressure and smoothing
jagged artifacts left over after compression.
1
• Press
S. RETRIEVER to switch the sound
retriever on or off.
Playing other sources
1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
3 Select the source you want to playback.
Use the input select buttons (
INPUT SELECTOR
).
4 Start playback of the component you
selected in step 1.
Selecting the multichannel
analog inputs
If you have connected a decoder or a DVD
player with multichannel analog outputs to this
receiver (page 13), you must select the analog
multichannel inputs for surround sound.
2
• Press
DVD 5.1
(VSX-516 model) / DVD5.1
(SHIFT+DVD) (VSX-416 model) on the remote
control or DVD 5.1 on the front panel.
To cancel playback from the multichannel
inputs, use the
INPUT SELECTOR
buttons to
select a different input signal.
Note
1 The Sound Retriever is only applicable to 2-channel sources.
2 During playback from the multichannel inputs, you can’t use any of the sound features/modes and only the volume and chan-
nel levels can be set.
VSX_516.book.fm 33 ページ ２００６年２月２１日 火曜日 午後４時５２分