Filter
Top Products
61
OPERATION
Remote Control of Other Components
memo
Locking the Settings
This feature allows you to lock the SYSTEM SETUP and REMOTE SETUP settings so that they cannot be
changed without unlocking them first. When they are locked you cannot enter the setting screen in these
modes. The locking and unlocking procedures are done by the same process.
1
In the SYSTEM SETUP or REMOTE SET
UP screens hold down the 5˜∞
buttons at the same time. While you're
holding down the buttons a lock
symbol will appear in the top bar of
the remote control.
2
Press the lock symbol while holding
down the above two keys. The setting
will either lock or unlock depending on
the state it was previously in.
From that time, if the screen is locked the lock symbol
will appear when that screen is accessed.
The only exception to LOCKING THE SETTINGS is the
LCD COMMANDER settings in the REMOTE SETUP
screen. They can still be accessed even when the
REMOTE SETUP screen is locked.
5
Point the two remote controls toward
each other. Press the button on the
other remote control corresponding to
the operation you want to program.
LEARNING flashes in the display on the VSX-39TX remote
control. After the process is complete and the command
has been learned, OK will appear at the top of the remote
control LCD display. If NG (no good) appears, it means
that for some reason the command was not learned.
Repeat steps 4 and 5 to teach the remote control of the
VSX-39TX all the commands from the other remote
control.
6
Press the BACK button to return to the
LEARNING/SELECT FUNCTION screen.
Start again from step 3 to program all your components in
this manner.
7
When you're done press the BACK
button repeatedly to return to the
REMOTE SETUP or RECEIVER menu.
memo
Some commands from other
remote controls cannot be
learned, but in most cases the
remotes just need to be moved
closer together or farther apart.
12-30 cm
(5-12 inches)
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
DVD:OK
1
2
4
7
8
9
5
6
3
SEARCH
MODE
TOP
MENU
SET UP
MENU
BACK
0
C
10
6
5
7
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
RECEIVER
Learning
Unlocked symbol
+
ENTER
RECEIVER
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
TUNER
TV
CONTROL
MUTING
MASTER VOLUME
SYSTEM
OFF
MULTI
OPERATION
STANDBY/ON
—
CH
+
FUNCTION
TV
CONTROL
VOL
—
CH
—
VOL
+
FUNCTION
BACK LIGHT
use lock
on/off
Remote Setup
LCD
COMMANDER
ITEM MEMO
KEY RENAME
MULTI OPERATION
DIRECT FUNCTION
PRESET RECALL
LEARNING
BACK
2
1
RECEIVER
DVD/LD
REMOTE
SETUP
MD/TAPE1
CH
+
FUNCTION
TV
CONTROL
use lock
Remote Setup
LCD
COMMANDER
DIRECT FUNCTION
BACK
Locked symbol