Filter
Top Products
1'- 2'
BLUETOOTH WIRELESS TECHNOLOGY
To use your
wireless technology device
with the SP-SB23W Speaker Bar System, you must
first pair your device with your Speaker Bar.
Pairing creates the ability for your
device
to connect with your Speaker Bar wirelessly and
exchange information.
You only have to pair your Speaker Bar with your
device one time for this exchange of
information to take place.
PAIR AND CONNECT YOUR BLUETOOTH DEVICE
1. Make sure your
device and Speaker
Bar are powered on and the
source
is selected on the speaker bar (Blue light above
logo is solid blue).
2. Activate the
function on your
source device and check it is actively
looking for a
device.
3. Press and hold the
Pairing button until
the
light begins to flash slowly.
4. Your speaker bar will now appear on your
source device. Select “SP-SB23W” on
your
device to initiate pairing.
5. After a few seconds your Speaker Bar will now be
paired with your
device and you can
enjoy music playback wirelessly. Note: only one
device can be connected to the Speaker Bar at
one time.
6. Using the included remote for your Speaker Bar,
you can track forward and back, Pause and Play
your current track, and turn the Volume Up and
Down.
AUTOMATIC CONNECTION
Any time you want to connect the last paired device
and play it through the speaker bar, do the following:
1. Turn your device’s
function On.
2. Enter
source by pressing the
source button from the remote.
By default, the last connected
device will automatically connect if available.
HOW TO DISCONNECT WITH A BLUETOOTH DEVICE
Turn off or disconnect the
feature on your
device.
TEACHING YOUR SPEAKER BAR TO RESPOND TO
ANOTHER REMOTE CONTROL
Your speaker bar
is currently programmed to respond to the remote
control that is included with the product. However, we
strongly recommend programming the speaker bar to
also respond to your existing remote control using the
steps illustrated below. This will enable you to operate
all of your components using a single remote control.
While programming the speaker bar, ignore anything
that may be displayed on the TV screen.
1. Power On the Speaker Bar and wait for the blue
light to become solid.
2. Using the SOURCE button select either Analog or
Digital Input.
3. Press and hold the Speaker Bar's BLUETOOTH/
PAIRING/LEARNING button until the
light flashes. Release the button. The light will now
turn solid blue.
4. Press the button on the Speaker Bar that you
would like to teach, the
light should
begin to flash slowly.
5. Point the remote control that you want to use for
your speaker bar and push the corresponding
command button that you chose in Step 4.
6. The
light should begin flashing quickly
and the mode light will flash green if the code
was accepted (if the mode light flashes red the
code was not accepted. Move the remote control
closer and push the button again). Now push your
remote's command button again and if the mode
light flashes green the command is now set.
7. Repeat this process for each button you would like
to teach your speaker bar.
8. To exit the learning mode press and hold the
BLUETOOTH/PAIRING/LEARN button until the
flashes. Then release the button. The
light is now off.
10
English