Filter
Top Products
7
En
8 Auto Standby switch (AUTO STANDBY)
Switches the Auto Standby feature on/off.
When switched
ON
(the default setting is
OFF
), the
Auto Standby feature becomes active. In this mode, if
there is no input signal for 12 minutes the system
automatically switches to standby. The power is
automatically switched on again if an input signal is
detected.
NOTE:
• There may be cases where a connected component
outputs noise or some other non-audio signal which
causes this system to automatically power on when in
Auto Standby mode. If this happens, switch off the
Auto Standby mode and switch the system on/off
manually.
9 Line Level Output terminal (LINE LEVEL OUTPUT)
Used for connecting other equipment through the
amplifier. The signal output from this jack is not
affected in any way by the settings of the various
controls on the unit.
10 Line Level Input terminal (LINE LEVEL INPUT)
Connect to the SUBWOOFER PREOUT terminal of an
amplifier or receiver, with the specially provided RCA
plug cord.
11 AC INLET
• Connect the power cord to the powered subwoofer
unit’s AC INLET.
• Connect the power cord to a AC socket.
CONNECTIONS
Before making or changing any connections, switch off the power and disconnect both this unit and the
amplifier/receiver from the AC outlet.
LINE LEVEL CONNECTION
This connection is for an amplifier or receiver equipped
with a
SUBWOOFER PREOUT
terminal. Connect to the
LINE LEVEL INPUT
terminal on this unit, using the
specially provided RCA plug cord.
NOTE:
• When connected to the
PREOUT
terminal for
surround center channel on the amplifier or receiver,
the bass is heard only on the center channel, so it will
be insufficient.
OPERATION
For details regarding operating part functions, refer to
page 6.
1. Turn the POWER switch (2) ON.
• If the unit’s power cord is connected to a switched AC
outlet on the amplifier or receiver and the switch is left
ON, the unit can be turned ON/OFF together with the
amplifier or receiver.
• If the unit cannot be connected to the amplifier or
receiver, turn the power to the amplifier or receiver ON
before turning the power to the unit ON. When turning
the power OFF, turn the power to the unit OFF before
turning the power to the amplifier or receiver OFF.
2. Operate the amplifier or receiver and adjust the
volume of the other speakers.
3. Adjust the volume of the bass with the VOLUME
knob (3).
• When necessary, operate the
CROSSOVER
knob (
4
)
and
PHASE
switch (
7
), and then adjust with the
VOLUME
knob (
3
). Set the
BASS MODE
switch (
6
) to
either
MUSIC
or
CINEMA
.
4. Turn the POWER switch (2) OFF.
• The power indicator disappears.
S-LX70W Music mode Frequency response
Frequency (Hz)
100
80
90
70
50
60
100
1000
40
10
10000
Sound pressure level (dB)
Non-bypass
(Crossover 200 Hz)
Bypass
S-LX70W (Rear Panel)
Supplied RCA plug cord
S_LX70W_En.book 7ページ ２００７年７月１０日 火曜日 午後３時９分