Filter
Top Products
4
En
• If the cables’ wires happen to be pushed out of the terminals,
allowing the wires to come into contact with each other, it
places an excessive additional load on the amp. This may cause
the amp to stop functioning, and may even damage the amp.
• After connecting the plugs, pull lightly on the cables to make
sure that the ends of the cables are securely connected to the
terminals. Poor connections can create noise and interruptions
in the sound.
• Be sure to connect wires to the correct terminal polarities
(
+
,
–
) at the speaker and amplifier, or the proper surround
effect will not be produced.
2 Paste the supplied wall mounting template on the area of
installation.
Attach the template level to the ground using an adhesive such as
tape. Make sure the template is straight to avoid mounting the
speaker crookedly. Pasting the template too close to the TV may
cause the TV to get in the way of the speaker when installing. Make
sure the template and TV do not overlap.
3 Temporarily attach the bracket (for wall) to the specified
location on the template.
Align the bracket (for wall) to the specified location on the template,
and temporarily attach with a screw (6 mm diameter screw
recommended) at location [A].
Adjust the attachment position of the bracket so that it is aligned
with the template.
4 Attach the bracket (for wall).
Attach bracket with screws (6 mm diameter screws recommended)
at the 4 locations [B] (recommended). Firmly tighten the screw [A]
that was used to temporarily attach the bracket to the wall as well.
To avoid speaker from wobbling or falling off, firmly attach bracket
at multiple locations.
• Afterwards, remove the template by tearing along the
perforations.
• The following illustration is an example of attaching the bracket
with screws at five locations: Screw location [A] and the 4
corners of screw location [B] (recommended).
5 Attach the bracket (for speaker) onto speaker.
Attach the bracket on with supplied screws (long) at the 4 screw
holes.
This speaker system adopts a unique design that controls the
directionality of the sound. Due to this feature, this speaker system
must be mounted differently depending on whether it is being
installed above or below the TV. Attach the brackets in the direction
described below.
Template
[A]
[B]
[B]
Television
When installing above the TV
When installing below the TV
S_LX70-C_En.book 4 ページ ２００７年９月２８日 金曜日 午後５時４２分