Filter
Top Products
6 7
DRC1402-A
En
7
English
1
2
3
4
5
6
7
8
9
a
* The S-DJ50X is shown in the illustration.
1
LEVEL dial
Use to adjust the sound level (volume).
2
HF LEVEL ADJ dial
Use to adjust high-frequency sounds.
You can select from –2 dB, –1 dB, 0 dB, and 1 dB.
3
AUTO STANDBY switch
Use to turn the auto standby function on or off.
When the auto standby function is turned on, the speakers
automatically enter standby mode if no input signal is
received for a certain period of time (approximately 25
minutes) and power consumption can be reduced. When
an input signal is received while the speakers are in standby
mode, the speakers will automatically resume from standby
mode.
•The illumination (POWER indicator) on the front panel turns
off when the speakers enter standby mode.
•When the input signal is weaker than a certain level, the
speakers may not automatically resume from standby
mode. In such cases, turn off the [
AUTO STANDBY
] switch
to use the speakers.
•To force the speakers to resume from standby mode, turn off
the [
POWER
] switch on the rear panel once, and turn it back
on after a few seconds.
4
XLR INPUT connector
XLR type balanced input connector. The connector’s pin array
is as follows: No. 1 Ground, No. 2 Hot, and No. 3 Cold.
5
TRS INPUT jack
Balanced-input phone jack.
CAUTION
Do not connect to both the XLR INPUT connector and the TRS
INPUT jack at the same time.
6
RCA INPUT jack
RCA pin-type unbalanced input jacks.
7
POWER switch
Use to turn the power on and off.
CAUTION
Before turning on the power, make sure to check that the
[
VOLTAGE SELECTOR
] switch is set to the appropriate voltage
for the country or region where the speakers will be used. If
the [
VOLTAGE SELECTOR
] switch is not correctly set, contact
a Pioneer service center and request that the set voltage be
changed and the fuse be replaced. At the time of shipment, a
fuse with the appropriate voltage setting is set in the product.
When it becomes necessary to change the voltage setting, the
fuse must be replaced.
8
VOLTAGE SELECTOR switch
This switch is used to select the appropriate voltage settings
for the country/region of use. It is not to be used by the
customer directly.
9
AC IN
Connect the accessory power cord here and to an AC
power outlet. Do not plug in the power cord until all other
connections have been completed. Use only the furnished
accessory power cord.
a
Fuse holder
Rear Panel Facilities