Filter
Top Products
En
11
English
Operation
Turn on main power.
Set the main POWER switch on speaker rear panel to
ON.
Set power ON/Standby.
Press the power ON/Standby button (on the controller
or speaker rear panel).
Select the desired input.
Press the INPUT SELECTOR button (on the controller or
speaker rear panel) to select the desired input source.
Adjust the sound volume.
If controller is connected:
Slowly rotate the controller’s LEVEL dial to adjust
the sound volume as desired.
If controller is not connected:
Slowly rotate the LEVEL dial on the speaker’s rear
panel to adjust the sound volume as desired.
Using the MUTE function
Press the controller’s MUTE/EQ button to set the MUTE
function to ON.
Setting the Equalizer
On the rear panel of the speaker, set the EQ ON/OFF
button to ON, then use the EQ LOW and EQ HIGH dials
to adjust the tone quality as desired.
Using the Equalizer
To set the equalizer to ON, press the controller’s
MUTE/EQ button and hold depressed for one second
or more, or else press the EQ ON/OFF button on the
rear panel of the speaker.
Power Save Function
Set the AUTO STANDBY ON/OFF switch (on speaker
rear panel) to ON.
When the following conditions are met for 60 minutes, the unit
will automatically switch to standby mode:
— The LEVEL dial, control buttons, and other dials and controls
are not operated.
— The speaker receives no input signal of –40 dBu or greater.
Note:
!
When two or more audio sources are connected:
When changing the INPUT SELECTOR setting, the sound
volume produced by the speakers may change greatly due to
differences in output settings on the different audio sources. To
avoid this, rotate the LEVEL dial fully counterclockwise (MIN)
before changing the INPUT SELECTOR setting, the readjust the
sound level as desired.
!
Sound from speakers may be distorted, depending on the
output level of the connected audio device. In this case, lower
the output level of the device.
!
If the equalizer control is adjusted toward the “+” side while
the sound volume is raised, distortion may occur. In this event,
lower the sound volume, or adjust the equalizer to a level that
does not cause distortion.
!
This unit is equipped with a self-resetting protection circuit.
In the event of an potentially damaging signal input, the
protection circuit may operate to prevent sound from being
generated from the woofer or the tweeter; if this happens,
either lower the sound volume (LEVEL dial) on the unit’s rear
panel, or lower the level of the signal input to this unit from the
connected source component, and wait for a few minutes. The
protection circuit will self-reset, and sound will be restored. If
the sound does not return to its original volume, the unit may
be damaged; in this event, consult one of the service stations,
or consult your dealer.