11
En
English
Other Information
Attaching/Removing the Grille Cover
This speaker system comes with grille covers which may be
attached and removed by:
1 To attach the grille cover, line up the holes on the speaker
with the inserts on the grill, and press firmly.
2 To remove the grille cover, grab it by its bottom with
both hands and gently pull toward you to separate the
bottom part of the grille from the speaker.
3 Slide your hands up to the middle section of the grille,
and once again pull gently toward you. This will remove the
middle section of the grille from the speaker.
4 Finally, repeat this same motion for the top part of the
grille, removing the grille entirely from the speaker.
Cleaning the speaker cabinet
With normal use, wiping with a dry cloth should be sufficient to
keep the cabinet clean. If necessary, clean with a cloth dipped in
a neutral cleanser diluted five or six times with water, and wrung
out well. Do not use furniture wax or cleansers.
Never use thinners, benzine, insecticide sprays or other chemicals
on or near this unit since these will corrode the surfaces.
Specifications
Enclosure. . . . . . . . . . . . . . . . . . . . . . . . . Bass-reflex floorstanding type
(magnetically shielded)
Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-way
Woofer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 cm (6
5
/16 inch) cone x2
Mid tweeter . . . . . . . . 14 cm (5
1
/2 inch) cone / 3 cm (1
3
/16 inch) dome
Nominal impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Ω
Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Hz to 100 kHz
Sensitivity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 88.5 dB (2.83 V)
Maximum input power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 160 W
Exterior dimensions . . . . . . 350 (W) mm x 1224 (H) mm x 541 (D) mm
13
3
/4 (W) in. x 48
3
/16 (H) in. x 21
5
/16 (D) in.
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48 kg/105 lbs. 13 oz.
Supplied accessories
Spike bases . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Mounting pads . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 types, 2 each
Metal catch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Screw (for metal catch) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Grille . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Operating instructions
Specifications and design subject to possible modification
without notice, due to improvements.
Magnetic shielding
This speaker system is magnetically shielded. However,
depending on the installation location, color distortion may occur
if the speaker system is installed extremely close to the screen of
a television set.
If this happens, turn off the television, then turn it on again after
15 min to 30 min. If the problem persists, place the speaker system
away from the television set.
is a trademark placed on a product with Pioneer’s Phase
Control technology. This technology enables high-grade sound
reproduction through each component by improving overall
phase matching.
Published by Pioneer Corporation.
Copyright © 2007 Pioneer Corporation.
All rights reserved.
S-3EX_EN.book 11 ページ 2007年6月19日 火曜日 午後3時21分