Pioneer PRS-D2200T Stereo Amplifier User Manual


 
15
ATitle (English)Specifications
Power source ........................................................................................................ 14.4 V DC (10.8 V to 15.1 V allowable)
Grounding system .......................................................................................................................................... Negative type
Current consumption ........................................................................................................ 25 A (at continuous power, 4 )
Average current drawn* ..........................................................................................................8 A (4 for two channels)
17 A (4 for one channel)
17 A (2 for two channel)
Fuse ........................................................................................................................................................................ 30 A × 2
Dimensions ........................................................................................................ 301 (W) mm × 57 (H) mm × 213 (D) mm
[12 (W) in. × 2-1/4 (H) in. × 8-3/8 (D) in.]
Weight .................................................................................................... 3.4 kg (7.5 lbs.) (Leads for wiring not included)
Maximum power output .......................................................................................... 300 W ×2 (4 ) / 1 200 W × 1 (4 )
Continuous power output .......................................................... 150 W × 2 (at 14.4 V, 4 , 20 Hz to 20 kHz 1.0% THD)
600 W × 1 (at 14.4 V, 4 , 1 kHz 1.0% THD)
300 W × 2 (at 14.4 V, 2 , 1 kHz 1.0% THD)
Load impedance ........................................................................................................................ 4 (2 to 8 allowable)
Frequency response .......................................................................................................... 10 Hz to 50 kHz (+0 dB, –3 dB)
Signal-to-noise ratio .................................................................................................................... 100 dB (IHF-A network)
Distortion ........................................................................................................................................ 0.005 % (10 W, 1 kHz)
Separation ...................................................................................................................................................... 70 dB (1 kHz)
60 dB (100 Hz to 10 kHz)
Low pass filter ............................................................................................................ Cut off frequency: 40 Hz to 500 Hz
Cut off slope: –12 dB/oct
High pass filter............................................................................................................ Cut off frequency: 40 Hz to 500 Hz
Cut off slope: –12 dB/oct
Bass boost ................................................................................................................................................ Frequency: 50 Hz
Level: 0, 6, 9, 12 dB
Gain control .................................................................................................................................... RCA: 400 mV to 6.5 V
Speaker: 1.6 V to 26 V
Maximum input level / impedance ...................................................................................................... RCA: 6.5 V / 22 k
Speaker: 26 V / 90 k
Power output ...................................................................................... 150 W RMS × 2 channels
(4 and 1 % THD+N)
600 W RMS × 1 channel
(4 and 1 % THD+N)
300 W RMS × 2 channels
(2 and 1 % THD+N)
Signal-to-noise ratio ............................................................ 80 dBA (Reference: 1 W into 4 )
Note:
Specifications and the design are subject to possible modification without notice
due to improvements.
*Average current drawn
The average current drawn is nearly the maximum current drawn by this unit
when an audio signal is input. Use this value when working out total current
drawn by multiple power amplifiers.