English
8
Published by Pioneer Corporation.
Copyright © 2008 Pioneer Corporation.
All rights reserved.
6. Tighten from below using the
supplied screws (three locations).
• Tighten the three screws in order
➀
,
➁
,
➂
as shown in
the diagram (see page 7).
The screw hole at the rear surface of the speaker bracket
is used when the flat screen TV is installed with the table
top stand. It is not used when installed on the wall.
NOTE:
If after attaching the speaker its position needs to be
adjusted horizontally, first loosen the speaker mounting
screws, reposition and then tighten the screws again at the
appropriate position.
7. Bundling the cables (See procedure 7
on page 6).
CABINET MAINTENANCE
• Use a polishing cloth or dry cloth to wipe off dust and dirt.
• When the cabinet is very dirty, wipe with a soft cloth
moistened with water-diluted cleanser; then wipe again
with a dry cloth. Do not use furniture wax or cleaners.
They may damage the surface of the cabinet.
• Never use thinner, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will
corrode the sur
faces.
• When a chemical cloth is used, read the cautions for the
chemical cloth carefully.
SPECIFICATIONS
Cabinet ............................................................Bass-reflex type
Used speaker (two-way system):
Woofer (for low tones) ................ 4.8 cm
×
13 cm cone type
Tweeter (for high tones) ....................2.5 cm semidome type
Impedance ...........................................................................6
Ω
F
requency Range ........................................55 Hz to 30 000 Hz
Sensitivity (1 m, 1 W) ....................................................... 80 dB
P
ermissible input :
Max. input ...................................................................... 18 W
Rated input ..................................................................... 6 W
Crossover frequency ........................................................3 kHz
External Dimensions
..............................1 465 (W) mm
×
78 (H) mm
×
93 (D) mm
Weight :
Speaker only ...............................................................3.15 kg
With cables, brackets and screws .............................. 3.7 kg
Accessor
y parts
................................................................. Speaker Cables
×
2
....................................................................Speaker Brackets
Left
×
1
Right
×
1
Center
×
1
......................Speaker Mounting Screws (M5
×
10 mm)
×
9
..................................................... Operating Instructions
×
1
NOTE:
Specifications and design subject to possible modification
without notice, due to impr
ovements.