Filter
Top Products
E-3
Catch the hooks on the top of the speakers to the partially
tightened screws, then line up the holes in the hooks on
the bottom of the speakers with the screw holes on the
bottom of the display and partially tighten the included
screws (M4) in them.
Fully tighten the four partially tightened screws.
Screws (M4)
When the speakers are installed on the display, do not move the unit by lifting up the speakers.
The display could fall and cause injury.
WARNING
*Push the speaker against the display while driving
the screw.
Connect the display’s EXT SPEAKER R and L
terminals with the speakers’ terminals using the
included connection cords.
Connecting the cords
Turn off the power of all connected units before connecting the cords.
While holding the button of each speaker
terminal, insert a conductor of the
connection cord.
Red
Black
There is polarity with the conductor of each
connection cord.
Connect each conductor to the correct terminal.
Peel off the protective tape from the back of
the clamper, then mount the clamper in the
desired position and clamp the cords
together.
Cord Clamper
R
L