Filter
Top Products
Getting started 04
13
En
English
Deutsch Italiano EspañolFrançais
Nederlands
Chapter 4
Getting started
Switching on
After making sure that everything is connected
properly and that the player is plugged in, push
the POWER button into the
ON
position to
switch the player on.
•Press CD PLAYER on the remote to
switch the unit into standby.
Playing discs
The basic playback controls for playing CDs,
SACDs, and MP3/WMA discs are covered
here. Further functions are detailed in Other
playback features on page 14.
1 If the player isn’t already on, press
POWER
to switch it on.
2 Press
(OPEN/CLOSE) to open the disc
tray.
3 Load a disc.
Load a disc with the label side facing up,
using the disc tray guide to align the disc.
Once properly seated, press to close the
disc tray.
4 Press
(play) to start playback.
Basic playback controls
The table below shows the basic controls for
playing discs.
ONOFF
POWER
STANDBY
PURE AUDIO
POWER OFF ON
CD PLAYER
OPEN/CLOSE
TIME
DIMMER
SACD/CD
PURE AUDIO
CLEAR ENTERENTER
LEGATO
LINK
123
456
78
0
9
CD PLAYER
OPEN/CLOSE
PURE AUDIO
123
456
78
0
9
Button What it does
Starts playback.
Pauses a disc that’s playing, or
restarts a paused disc.
/
(front panel
only)
Starts playback/stops a disc that’s
playing.
• While depressing /, press
(front panel only). Counting from the
first track on the disc, playback will
begin from the track number
corresponding to the number of
times is pressed.
Stops playback.
PD-D9MK2_en_CUXJ.book 13 ページ ２００９年４月３日 金曜日 午後８時５２分