Filter
Top Products
Adjusting initial settings
1 Press OFF and hold until the unit turns
off.
2 Press MULTI-CONTROL and hold until
CLOCK SET appears in the display.
3 Turn MULTI-CONTROL to select one of
the initial settings.
CLOCK SET (clock)—FM STEP (FM tuning
step)—AM STEP (AM tuning step)—
WARNING TONE (warning tone)—AUX (aux-
iliary input)—SW CONTROL (rear output and
subwoofer controller)—EVER SCROLL (ever
scroll)
# You can also perform the same operations by
pushing MULTI-CONTROL upor down.
# You can also select thefunction by pressing
FUNCTION on the remote control.
# To cancel initialsettings, press BAND/ESC.
Setting the clock
Use these instructions to set the clock.
1 Use MULTI-CONTROL to select
CLOCK SET.
2 Press MULTI-CONTROL to display the
setting mode.
# Press BACK toreturn to the previous display.
3 Press MULTI-CONTROL to select the seg-
ment of the clock display you wish to set.
Each time you press MULTI-CONTROL, one
segment of the clock display is selected.
Hour—Minute
As you select segments of the clock display,
the selected segment blinks.
4 Turn MULTI-CONTROL to put a clock
right.
# You can also perform the same operations by
pushing MULTI-CONTROL upor down.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
! If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune
in the stations with manual tuning or use
seek tuning again.
1 Use MULTI-CONTROL to select FM STEP.
2 Press MULTI-CONTROL to display the
setting mode.
3 Turn MULTI-CONTROL to select the FM
tuning step.
Turning MULTI-CONTROL will switch the FM
tuning step between 50 kHz and 100 kHz. The
selected FM tuning step will appear in the dis-
play.
# You can also perform the same operations by
pushing MULTI-CONTROL upor down.
Note
The tuning step remains at 50 kHz during manual
tuning.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
kHz to 1602 kHz allowable) to 10 kHz (530 kHz
to 1640 kHz allowable).
1 Use MULTI-CONTROL to select
AM STEP.
2 Press MULTI-CONTROL to display the
setting mode.
Initial Settings
En
22
Section
04