Filter
Top Products
Listening to your system 04
13
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Making an audio recording
You can make an audio recording from any
audio source connected to the amplifier.
1 Select the source you want to record.
Use the input select buttons (INPUT
SELECTOR).
2 Prepare the source you want to record.
Tune to the radio station, load the CD, set up
the turntable, etc.
3 Prepare the recorder.
Insert a blank tape, MD, etc. into the recording
device and set the recording levels.
1
Refer to the instructions that came with the
recorder if you are unsure how to do this.
4 Start recording, then start playback of the
source component.
Note
1 The amplifier's volume, balance and tone controls have no effect on the recorded signal.
A9_MY.book Page 13 Tuesday, October 10, 2006 10:40 AM