Filter
Top Products
4
• If your receiver has no subwoofer output jack but has pre-amp left & right channel outputs you can
connect your subwoofer directly to your receiver's pre-amp outputs using the L & R Line Input jacks. If
your receiver uses jumpers to connect its pre-amp outputs with its amp stage inputs you will need to
acquire two splitter cables (such as Radio Shack #42-2535) to be able to hookup your sub while
continuing to provide a signal to your receiver's amp stage inputs. Note: Do not connect your subwoofer
to the tape loop outputs from your receiver as they will overdrive its circuitry!
• If you have a Dolby Digital or DTS receiver place the subwoofer's Crossover Bypass switch in the ON
position (this bypasses the Low Pass Filter in the subwoofer). If you do not have a Dolby Digital or DTS
receiver place the subwoofer's Crossover Bypass switch in the OFF position (this activates the Low Pass
Filter in the subwoofer).
• Lastly, wire your left and right front speakers directly to your receiver’s speaker outputs. Please refer to
the Option #1 wiring diagram for further clarification.
CONNECTION OPTION #2 - Using The Binding Post Inputs: