Filter
Top Products
Amplier Owner’s Manual
Phoenix Gold • www.phoenixgold.com
SPECIFICATIONS
Ti2 1300.1 SPECIFICATIONS
Frequency Response: ± 1dB from 20Hz to 200Hz
Signal to Noise Ratio: >90dB
Low Pass Crossover: 24dB per Octave
Subsonic Filter: 48dB per Octave
Low Pass Crossover Range: 30Hz to 200Hz
Subsonic Crossover Range: 10Hz to 55Hz
Bass Boost @ 45Hz: 0 to +18dB
Low Level Input Range: 200 millivolts to 8 volts
Lowest Recommend Load: 1 ohm
Typical Eciency: 80%
Damping Factor: Greater than 200
Variable Phase Adjustment: 0 to 180 Degrees
RMS Power Output 900w x 1 @ 2 ohms
1300w x 1 @ 1 ohm
Power/Ground Wire Size: 4 Gauge
Recommend Power Wire Fuse: 100a
Dimensions (Includes Feet): 14.4” L x 7.1” W x 2.0” H
366mm L x 180mm W x 52mm H
IMPORTANT: A power birth certicate is included for each amplier. Ti2 ampliers
are conservatively rated and will exceed their RMS power rating shown here. All
RMS power ratings and measurements are at 14.4 volts with no more than 1% THD.
Ti2 800.1 SPECIFICATIONS
Frequency Response: ± 1dB from 20Hz to 200Hz
Signal to Noise Ratio: >90dB
Low Pass Crossover: 24dB per Octave
Subsonic Filter: 48dB per Octave
Low Pass Crossover Range: 30Hz to 200Hz
Subsonic Crossover Range: 10Hz to 55Hz
Bass Boost @ 45Hz: 0 to +18dB
Low Level Input Range: 200 millivolts to 8 volts
Lowest Recommend Load: 1 ohm
Typical Eciency: 80%
Damping Factor: Greater than 200
Variable Phase Adjustment: 0 to 180 Degrees
RMS Power Output 600w x 1 @ 2 ohms
800w x 1 @ 1 ohm
Power/Ground Wire Size: 4 Gauge
Recommend Power Wire Fuse: 80a
Dimensions (Includes Feet): 11.7” L x 7.1” W x 2.0” H
296mm L x 180mm W x 52mm H