Filter
Top Products
Coaxial Speaker Owner’s Manual
© 2010 Phoenix Gold • www.phoenixgold.com
T/S Parameters R4CX R46CX R5CX R57CX R65CX R69CX
RMS Power Handling (watts) 40W 40W 40W 50W 50W 60W
Peak Power Handling (watts) 80W 80W 80W 100W 100W 120W
Impedance (ohms) 4 4 4 4 4 4
Cut Out Dimension (mm) / in. (93) 3.7 (143 X 88) 5.6 X 3.5 (120) 4.75 (188 X 131) 7.4 X 5.2 (144) 5.7 (221 X 154) 8.7 X 6.1
Mounting Depth (mm) / in. (50) 2.0 (51.5) 2.1 (55) 2.2 (71) 2.8 (64) 2.5 (76) 3.0
BASIC INSTALLATION Selecting the placement of your new R Coaxial
speakers could be as easy as using the existing factory locations or may
require you to create a new location. Speaker placement in the door, dash,
or rear deck is the most common. See your local Phoenix Gold Dealer for
additional location and mounting assistance.
DOORS /REAR DECK
1. Many vehicles already have factory locations (Figure 1) to house the “DROP
IN” feature of the R Coaxial speakers. If no existing locations are available
or are not used, check the desired location for adequate cutout area and
any depth obstructions. Make sure to allow sufcient clearance for window
tracks, structural braces, trunk lid springs, etc.
2. Assuming enough area and depth is available, use the provided template
and trace the speaker cutout and mounting holes onto the surface of the
mounting location.
3. If the mounting surface is not structurally strong enough to accommodate
screws, (i.e. plastic, cardboard) use the pro vided speed clips which will act
as a nut for the supplied screws.
4. Always provide water protection, if not supplied in the vehicle. We suggest
using a rain shield or equivalent. If in doubt, please contact your
Phoenix Gold Dealer.
SPEAKER INSTALLATION WITHOUT GRILL
Phoenix Gold has provided a foam mounting gasket. When installing your
new component speakers in a factory location make sure to use the foam
mounting gasket as shown in gure 1. For reverse mounted speakers place the
foam gasket in front of the speaker. This will ensure an air tight seal for your R
speakers.
For more custom applications, or cases where the factory grill will not be used,
a high excursion protective grill has been provided. When installing your new
component speakers with the provided R grill use gure 2.
SPECIFICATIONS: Due to continual product improvement, all specications subject to change without notice.
Figure 1
Mounting the speaker in a factory location.
Figure 2
Mounting the speaker in a custom application.