Filter
Top Products
Make sure your hands and the unit are dry when you insert the batteries.
1 Slide the battery compartment lid downwards to remove it (Fig. 7).
2 Insert the two batteries (Fig. 8).
Make sure the + and – poles of the batteries point in the right direction.
3 Slide the battery compartment lid back onto the back of the parent unit until it locks into
position (‘click’) (Fig. 9).
Note: When the batteries are running low, the battery check light ( T) on the parent unit ashes red.
Using the appliance
1
Place the parent unit and the baby unit in the same room to test the connection (Fig. 10).
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
2 Press and hold the on/off button 3 on the baby unit for 2 seconds. (Fig. 11)
The ON light lights up.
3 Press and hold the on/off button 3 on the parent unit for 2 seconds. (Fig. 12)
The sound level lights light up blue briey.
The battery check light lights up briey.
The LINK light lights up red briey and then starts to ash green while the parent unit tries
to establish connection with the baby unit.
The LINK light on the parent unit ashes green until connection has been established. This
takes up to 30 seconds. The LINK light on the parent unit then lights up green continuously.
If no link is established after 30 seconds, the LINK light on the parent unit ashes red and the
parent unit beeps from time to time.
4 Place the baby unit at least 1 metre/3 feet away from your baby (Fig. 13).
5 Position the parent unit within the operating range of the baby unit. Make sure it is at least 1
metre/3 feet away from the baby unit (Fig. 14).
For more information on the operating range, see section ‘Operating range’ below.
Operating range
The operating range of the baby monitor is 300 metres/900 feet in open air. Depending on the
surroundings and other disturbing factors, this range may be smaller. Indoors the operating range is
up to 50 metres/150 feet.
Dry materials Material thickness Loss of range
Wood, plaster, cardboard, glass
(without metal, wires or lead)
< 30cm/12in 0-10%
Brick, plywood < 30cm/12in 5-35%
Reinforced concrete < 30cm/12in 30-100%
Metal grilles or bars < 1cm /0.4in 90-100%
Metal or aluminium sheets < 1cm/0.4in 100%
For wet and moist materials, the range loss may be up to 100%.
,
,
,
,
,
,
,
ENGLISH8