Filter
Top Products
November 1982 6
Philips Semiconductors Product specification
1 to 4 W audio power amplifier TDA1015
Notes
1. Measured with an ideal coupling capacitor to the speaker load.
2. Measured with a load resistor of 20 kΩ.
3. Measured at P
o
= 1 W; the frequency response is mainly determined by C1 and C3 for the low frequencies and by
C4 for the high frequencies.
4. Independent of load impedance of preamplifier.
5. Unweighted r.m.s. noise voltage measured at a bandwidth of 60 Hz to 15 kHz (12 dB/octave).
6. Ripple rejection measured with a source impedance between 0 and 2 kΩ (maximum ripple amplitude: 2 V).
7. The tab must be electrically floating or connected to the substrate (pin 9).
Fig.3 Test circuit.