Filter
Top Products
Press on the remote control or transmitter in standby mode to turn it on.
Press the source buttons: 1 HDMI , 2 HDMI , 3 INPUT , 4
INPUT on the remote control or transmitter until you
see the available video from your device.
You can either place the receiver near the HDTV or mount
it on the wall.
1 Choose a spot near the TV.
2 Drill two holes in the wall. Ensure the distance
between the two holes is 4.5mm.
3 Punch the supplied plastic wall anchors into the two
holes on the wall.
4 Put the two screws into the plastic wall anchors and
leave 3.2mm to mount the receiver on.
5 Hook the receiver on the wall.
Switch on the transmitter
Select the source on the transmitter
Wallmount the receiver
Note
In standby mode, a red power LED displays on the •
transmitter .
Depending on equipment and the input selected, •
between input selection/start-up and being able
to see the image on your TV can take up to 15
seconds.