Filter
Top Products
9
SP
Warranty
8
EN
Assembly
Lead-In Wire
• Attach lead-in wire to house with screw-type standoffs.
• Tighten standoffs with pliers after wire is installed.
• Avoid sharp bends in lead-in wire.
• Form drip loop where wire enters wall.
• Wall mounts not included.
• Mounts, mast and standoffs are not included.
Band Separator
• Attach band separator to appr
opriate terminals on TV set.
• Attach antenna lead-in wire to band separator.
• An FM set or second TV set may be attached to second output
of band separator.
NOTE: Band separator is only required for older TV sets with sep-
arate VHF/UHF inputs. For most newer sets, simply connect cable
from antenna to ‘F’ input.
Wall
To Signal
Splitter
Drip
Loop
Limited Lifetime Warranty
The manufacturer warrants that this product shall be free from
defects in material, workmanship and assembly, under normal use, in
accordance with the specifications and warnings, for as long as you
own this product. This warranty extends only to the original pur-
chaser of the product, and is not transferable. Defective products,
together with the dated proof of purchase, must be returned to the
place of purchase for repair or replacement. THERE ARE NO
OTHER EXPRESS WARRANTIES. Incidental and consequential
damages are disclaimed where permitted by law. This warranty gives
you specific legal rights, and you may also have other rights which
vary from state to state.
Technical Support
For Technical support send an email with the model number of the
product and a detailed description of your problem to:
Email: tech.support@philips.com
©2006
Accessories Service Center
Philips
Accessories and Computer Peripherals,
Ledgewood, NJ 07852 USA
Quality assured in USA
Printed in China
Technical Support