Philips WAS700 Stereo System User Manual


 
19
English
Remove the protective
plastic tab before using the
Station’s remote control.
Always point the remote
control directly towards IR area on the
Center or Station you wish to operate.
Using Center’s remote control
By default, Center’s remote control works with
Center only. To operate Station using Center’s
remote control,
1 Press and hold REFRESH until the select
screen appears on the display of Center’s
remote control.
Preparation
Using the remote control
WAS700 is equipped with a remote control.
You can use it to operate both Center and
Station.
IMPORTANT!
IMPORTANT!
Center’s remote control will return to its
default setting (works with Center only)
when you insert new batteries into it.
Avoid placing your Center or Station
close to the plasma TV. It may resuit in
improper display on your Center’s remote
control.
Helpful hints:
To operate Center using the remote control
again, repeat the above steps 1-2 to select Center.
To replace the remote controls’
battery
1 Press and hold 1 as indicated.
2 Simultaneously, pull the battery tray at 4.
3 Remove the old battery and put a new CR2025
battery in place.
4 Put back the battery tray.
C
R
2
0
2
5
L
I
T
H
I
U
M
2
3
1
CAUTION!
Remove the battery if it is exhausted
or will not be used for a long time.
Batteries contain chemical substances,
so they should be disposed of properly.
Using the navigation controls
When selecting options on the set’s screen, you
often need to use the navigation controls 1 / 2
/ 3 / 4.
1 Press 3 / 4 to highlight an option.
2 Enter its submenu by pressing 2.
3 Press 1 to return to the previous option list
screen.
4 Press OK or 2 to confirm
2 Press the navigation controls 3 or 4 and 2
to select Station
On Center’s remote control:
Display shows current status of Station
after Station is connected
You can use Center’s remote control to
operate Station now
Some functional keys on Center’s remote
control are exclusively used for Center (for
example, CD/MP3-CD, MARK/UNMARK,
MUSIC BROADCAST etc.)
P001-P033_WAS700_Eng 9/28/2005, 14:5819