Filter
Top Products
36
English
3139 115 21993
Setting the timer
The system can switch on to DISC or TUNER
mode automatically at a preset time, serving as
an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that
the clock is set correctly.
– The volume of the timer will increase
gradually to the last tuned volume level.
If the last tuned volume level is too low,
the set will then increase to a
predetermined minimum audible level.
SEARCH
SOURCE
CLOCK•TIMER
CLOCK•TIMER
TU 12:00 AM
CD 12:00 AM
SELECT CLOCK OR
CLOCK•TIMER
TIMER
2
3
5
4
6
1 Press STANDBY ON to switch on the DVD
system.
2 Press and hold CLOCK•TIMER until
"SELECT CLOCK OR TIMER" appears.
3 Press T (if necessary) to change the display
to "TIMER", then press CLOCK•TIMER again
to confirm.
4 Adjust SOURCE (or press DISC/MEDIA or
TUNER on the remote) to select the wake up
source (DISC or TUNER.)
5 Press S / T to set the wake up time
(minutes and hours.)
To increase the speed, hold down S or T.
➜ The changes in minutes will roll over to the
hours.
6 Press CLOCK•TIMER again to store the
setting.
➜ Once the timer is set, it will always switch on
unless you deactivate it.
➜ icon will remain on the display panel. It
indicates the timer is activated.
● At the preset time, the selected sound
source will play for 30 minutes before it
switches to Eco Power standby mode (if
no button is being pressed within the time
frame.)
➜ DISC – the first track of the last selected disc
will be played. If the last selected disc tray is
empty, it will switch to the next available disc. If
all the disc trays are not available, it will switch
to Tuner mode.
➜ TUNER – the last tuned radio station will be
played.
Activating/Deactivating the timer
1 Repeat steps 1~3 of “Setting the timer.”
2 Press Ç to turn off the timer.
➜ icon will disappear from the display panel
and "TIMER OFF" appears.
OR
Press CLOCK•TIMER to turn on the timer to
the last setting.
➜ The timer information will display for a few
seconds, then the system resumes its last active
source or stays in standby mode.
Note:
– The system will exit timer setting mode if no
button is pressed within 90 seconds.
Timer Operations
buttons on
front panel
DVD system’s
display panel
pg 001-044_MX39-37-Eng1 2/25/03, 9:59 AM36