Filter
Top Products
5 To interrupt playback press PLAY•PAUSE 2; (on the
remote control SIDE/ ;). Press PLAY•PAUSE 2; (on the
remote control 2) again to resume play.
™ The display freezes and the elapsed playing time
flashes when playback is interrupted.
6 To stop CD playback, press STOP 9.
Note: CD play will also stop when:
– the CD door is opened
– the CD has reached the end
– you select another source: TAPE, TUNER or AUX
– you press to standby
– you press the tape deck PLAY
2
key
Selecting a different track
• Press PREV ¡1 or NEXT 2™ on the set, (on the remote
control ¡ or ™) once or repeatedly until the desired
track number appears in the display.
• If you have selected a track number shortly after loading
a CD or in the PAUSE position, you will need to press
PLAY•PAUSE 2; (on the remote control 2) to start
playback.
Finding a passage within a track
1 Press and hold down on PREV ¡1 or NEXT 2™.
– The CD is played at high speed and low volume.
2 When you recognize the passage you want, release
PREV ¡1 or NEXT 2™.
– Normal playback continues.
Note: During a CD program or if SHUFFLE/ REPEAT active,
searching is only possible within the same track.
Different play modes: SHUFFLE and REPEAT
You can select and change the various play modes before
or during playback. The play modes can also be combined
with PROGRAM.
SHUFFLE . . . . . . . . . . tracks of the entire CD/ programme
are played in random order
SHUFFLE and
REPEAT ALL. . . . . . . . to repeat the entire CD/ programme
continuously in random order
REPEAT ALL. . . . . . . . repeats the entire CD/ programme
REPEAT . . . . . . . . . . . plays the current track continously
1 To select your play mode, press the SHUFFLE or REPEAT
button before or during playback until the display shows
the desired function.
2 Press PLAY•PAUSE 2; (on the remote control 2) to
start playback if in the STOP position.
™ If you have selected SHUFFLE, playback starts
automatically.
3 To return to normal playback, press the respective
SHUFFLE or REPEAT button until the various SHUFFLE/
REPEAT modes are no longer displayed.
– You can also press STOP 9 to cancel your play mode.
Programming track numbers
Programme in the STOP position to select and store your CD
tracks in the desired sequence. If you like, store any track more
than once. Up to 20 tracks can be stored in the memory.
1 Press PROGRAM on the set or remote control to enter
the programming mode.
™ A track number is shown and PROGRAM flashes.
2 Use the PREV ¡1 or NEXT 2™ on the set, (on the
remote control ¡ or ™) to select your desired track
number.
3 Press PROGRAM to confirm the track number to be
stored.
™ The number of tracks programmed and total playing
time of the programme is shown briefly, then the
selected track and PROG.
4 Repeat steps 2-3 to select and store all desired tracks.
™ FULL is displayed if you attempt to programme more
than 20 tracks.
TIMER
CD
PROGRAM
MC 118 MICRO SYSTEM
OPEN•CLOSE
VOLUME
INCREDIBLE
SURROUND
DBB
DSC
INTERACTIVE SOUND
STANDBY
ON
TIMER
ON • OFF
PROGRAM
SELECT
RDS
CLOCK
SHUFFLE
REPEAT
BAND
IR
SENSOR
8
MC 118 / 22 page 8
English