Filter
Top Products
Parts included:
1. MANT940 Antenna . . . . . . . . . . . . . . . . . . . . 1
2. Power supply 120V to 6VDC . . . . . . . . . . . . 1
3. Wall / Mast Bracket. . . . . . . . . . . . . . . . . . . . 1
4. Nuts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
5. U-Bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
6. Mast clamps . . . . . . . . . . . . . . . . . . . . . . . . . . 2
7. Nuts with lock washers . . . . . . . . . . . . . . . . . 4
7. L-Bracket. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
8. 2" Wood Screws. . . . . . . . . . . . . . . . . . . . . . . 4
9. 20' coax cable with connectors. . . . . . . . . . . 1
10. Weather Boot. . . . . . . . . . . . . . . . . . . . . . . . . 1
11. Power Injector . . . . . . . . . . . . . . . . . . . . . . . . 1
12. Plastic Anchors . . . . . . . . . . . . . . . . . . . . . . . . 4
Determining signal strength
Before Installation determine the best location for optimum
reception. It is important for the antenna to have an unobstructed
path to the transmitter.To determine the transmitter(s) location you
can consult the website http://www.antennaweb.org.For best results
the antenna should be facing the transmitter location.
For indoor wall mount installation:
NOTE: Do all antenna assembly work on the ground before
installing on a wall or an antenna mast.
1. Attach main body to the L – bracket as shown, using cross
head scr
e
w note the orientation of the bracket. Do not fully
tighten the screw to allow for later adjustment (fig. 1).
2. Using the Wall/Mast bracket as a guide, mark position for the
f
our 2” wood scr
e
ws.
If possible locate a stud to scr
ew into.
If a stud is not a
vailable
,
use a
ppr
opriate wall anchors (not
included,
a
vailable at any hardware store) (fig. 2).
EN
Parts Included
5
Mounting Instructions
Wall Mount
fig.1
fig.2
MANT940 Instruct Eng Sp_SM 10/8/07 4:38 PM Page 5