Filter
Top Products
3139 116 19511 ( ENG)
11
7 Adjust the sound
of all the speakers
until they are equal.
When you are
satisfied with the
setting, press
TEST TONE again to switch off
the test signal.
Note:
– It is advisable to set the speakers’ level
at normal listening level. "XX" denotes
the sound level.
When you have completed the Dolby
Pro Logic setup, you are ready to enjoy
Home Cinema sound.
• Press DPL (PRO
LOGIC)
repeatedly to
select and cycle
through the
various sound
modes.
Dolby Surround ™ Center
Phantom ™ Dolby 3 Stereo ™
Stereo ™ Dolby Surround …
™ The Dolby Pro Logic display panel
will light up with the selection.
Dolby Surround
This setting is for a full Dolby Surround
Pro Logic mode.
• Press DPL to select the Dolby
Surround mode.
™ The message
“DOLBY
SURROUND”
will be
displayed.
™ The DPL
display panel
will light up.
Dolby Center Phantom
This setting is for use without the
center speaker. It redistributes the
center speaker sound to the left and
right speakers, providing conventional
stereo across the front.
• Press DPL to select the Dolby Pro
Logic Center Phantom mode.
™ The message
“CENTER
PHANTOM”
will be
displayed.
™ The DPL
display panel
will light up.
Dolby 3 Stereo
Use this setting when full surround is
not required, but a wide stereo sound is
desired. It only requires the left, right
and center speakers.
• Press DPL to select the Dolby 3
Stereo mode.
™ The message
“DOLBY 3
STEREO” will
be displayed.
™ The DPL
display panel
will light up.
Normal Stereo
This setting is for normal stereo sound
without Dolby Pro Logic. It only
requires the left and right speakers.
• Press DPL to select the Stereo
mode.
™ The message
“STEREO”
will be
displayed.
™ The DPL
display panel
will light up.
SS
LR
C
PRO LOGIC
SS
LR
C
PRO LOGIC
SS
LR
C
PRO LOGIC
SS
LR
C
PRO LOGIC
A
USE
TEST TONE
Å
L
UME
É
BALANCE
á
à
Ç
DPL
L
R
Important!
1 For the best Dolby Pro Logic
sound, switch on DPL with DSC
set to “Classic”.
2 Dolby Pro Logic mode will
automatically switch to normal
Stereo mode when headphones
are connected.
3 Switch to normal stereo mode
when you record on a tape.
DOLBY PRO LOGIC