Filter
Top Products
20
English
Tuner
Tuning to radio stations
1 Press SOURCE once or more to select FM
(or FM on the remote control) .
2 Press and hold 4 / ¢ (or 5 /6 on the
remote control) until SEARCH appears
➜ The radio automatically tunes to a station
with sufficient reception. Display shows SEARCH
during automatic tuning.
3 Repeat step 2 if necessary until you find the
desired station.
● To tune to a weak station, press 4 / ¢
(or 5 /6 on the remote control) briefly and
repeatedly until you have found optimal
reception.
Programming radio stations
You can store up to a total of 20 FM radio
stations in the memory,.
Automatic programming
Automatic programming will start from preset 1
or a chosen preset number. From this preset
number upwards, former programmed tuner
stations will be erased. The set will only program
stations which are not in the memory already.
1 Press the ALBUM/PRESET 43 (or ¡ / ™
on the remote control) buttons once or more
to select the preset number where programming
should start.
Note:
– If no tuner preset number is selected, default is
preset 1 and all your presets will be erased.
2 Press and hold PROG on the remote control)
until AUTO PROGRAM appears.
➜ Available stations are programmed: RDS
stations followed by FM stations (See RDS).
➜ After all stations are stored, preset station 1
will then be played.
Manual programming
1 Tune to your desired station (see Tuning to
radio stations).
2 Press PROG on the remote control) to activate
programming.
3 Press ALBUM/PRESET 43 (or ¡ / ™ on
the remote control) to allocate a number from 1
to 20 to this station.
4 Press PROG on the remote control) to
confirm.
➜ Display shows the preset number, waveband
and the frequency of the preset station.
5 Repeat steps 1-4 to store other stations.
● You can erase a preset station by storing another
frequency in its place.
To listen to a preset station
● Press the ALBUM/PRESET 43 (or ¡ / ™
on the remote control) buttons once or more
until the desired preset station is displayed.
● You can also use the Numerical Keypad
(0~9) to input a number directly and tune to
the station associated with this number.
● To input a number larger than 10, press SHIFT
once or more to select the first digit you want
and then use the Numerical Keypad (0~9)
to input the second digit.
pg 001-029_MCB395_05-04 2008.5.2, 17:3220