Philips MC-220 Speaker System User Manual


 
17
English
3140 115 30141
Tape Operation / Recording
Tape playback
1 Select TAPE source.
The display shows TAPE briefly. The tape
counter TAPE 000 display with the SIDE A or
SIDE B and reverse mode status are then shown
during tape mode.
2 Press OPEN to open the tape door.
3 Insert a recorded tape and close the tape door.
Load the tape with the open side downward and
the full spool to the left.
4 Press PLAYPAUSE 2; (on the remote
control 2;) to start playback.
5 By pressing ¡1 or 2™ on the system (on the
remote control à or á), fast winding of tape is
possible in both directions.
During fast winding, you can monitor the tape
message with the tape counter.
6 To stop the tape, press STOP 9 .
To reset the tape counter, press STOP 9 again.
Note:
The sound source cannot be changed while
recording a tape.
Switching tape sides
The tape side can be switched manually or
automatically before or during tape playback.
Press SIDE A/B (during playback only 2; on
the remote control).
The display shows SIDE A or SIDE B and the
tape counter resets to 000.
Reverse mode options
Press REV MODE repeatedly to select your
option;
å : playback stops at the end of the tape.
: both sides are played once.
: both sides are played repeatedly, up
to 5 times each side.
General information on
recording
Recording is permissible insofar as copyright or
other rights of third parties are not infringed.
For recording, use only NORMAL (IEC type I)
tapes on which the tabs have not yet been
broken. This deck is not suited for recording on
METAL (IEC IV) type tapes.
The best recording level is set automatically.
Altering the VOLUME, INCREDIBLE
SURROUND, DBB or INTERACTIVE SOUND
controls will not affect the recording in progress.
At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.