Filter
Top Products
13
English
Installation
Using AC power
1 Make sure all connections have been made
before switching on the power supply.
2 Connect the power cable supplied to
AC ~ and to the wall socket. This switches on
the power supply.
When the system is switched to standby, it is still
consuming some power. To disconnect the
system from the power supply completely,
remove the power plug from the wall
socket.
The type plate is located on the rear of the
set.
Inserting batteries into the
remote control
Insert two batteries type R06 or AA into the
remote control with the correct polarity as
indicated by the "+" and "-" symbols inside
the battery compartment.
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a
long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical
substances, so they should be disposed
off properly.
1
2
3
p001-p021_MAS85_21-Eng 5/7/05, 11:4913