Filter
Top Products
7
EN
Assembly
• Attach one 46˝ Element to hole A in VHF Boom-B.
• Attach one 50˝ Element to VHF Boom-B.
Repeat each steps with second boom for VHF Boom-B.
• Insert VHF Boom-B into VHF Boom-A and secure
using 1-1/2˝ screw and lock washers. Repeat steps
for 2nd boom as well.
• Attach tubing brace to rear of VHF Boom with 1-
1/2˝ screws and wing-nuts.
• Slide UHF Boom through center slot of VHF Boom
support block until hole A of UHF Boom aligns with
hole B of VHF Boom. Secure with 1-1/2˝ screw
and wing-nut.
• Attach phasing wire and lead-in wire to UHF antenna
using 3/4˝ screws, washers, and wing-nuts.
• Insert end caps at ends of all booms.
Mast Assembly (Mast not included)
• Assemble U-bolts to cross pieces.
• Use saddle on center of boom.