Philips HTS6520/93 Home Theater System User Manual


 
34
Note
This Home Theater System can store up to a
maximum of 40 radio stations.
If auto installation is not activated or less
than 5 radio stations are stored, you will be
prompted to install the radio stations again.
Listen to radio
1 Press RADIO .
2 Use the remote control to control the
radio.
Button Action
Selects a preset radio station.
Tunes the radio frequency up or
down.
Press and hold this button to
erase the current radio station
from the preset list.
The preset number for other
radio stations remain unchanged.
Tip
Press AUDIO SYNC to toggle between FM
stereo and FM mono mode.
Reinstall all the radio stations
1 Press RADIO .
2 Press and hold PROGRAM for more than
5 seconds.
All previously stored radio stations are »
replaced.
Note
Check the radio antenna connection if no
stereo signal is detected or less than 5 stations
are detected during radio installation.
Play from radio
Check if the FM antenna has been connected
to this Home Theater System. If not, connect
the supplied FM antenna to the FM75
jack
and À x its ends to the wall.
Tip
For better FM stereo reception, connect an
external FM antenna (not supplied).
Position the antenna as far away as possible
from your TV, VCR or other radiation source
to prevent interference.
First time tuning
When you access to radio mode for the À rst
time, follow the instructions to install the radio
stations.
1 Press RADIO .
’AUTO INSTALL ... PRESS PLAY’ is »
displayed.
2 Press .
All detected radio stations are stored. »
Once complete, it tunes to the À rst »
preset radio station.
To stop auto tuning, press
.
FM ANTENNA
(75 Ω)
EN