Filter
Top Products
English
11
Troubleshooting
Distorted sound – Check the volume on audio source/ headphone is not
set at too high a level.If the transmitter’s power
indication LED starts blinking: set the input selector
switch to 3 V or reduce the audio volume of the audio
source.
– Distance from the transmitter is too large. Move closer
to the transmitter.
– Interference from fluorescent lamps/ other radio
sources. Move transmitter or headphone elsewhere/
change the transmitter’s channel.
– Make use of the HC8902 transmitter.Some
transmitters already built into other equipment may not
be compatible with the HC8905 headphone because of
the advanced technologies used in the HC8905
headphone.
– The SRS™ surround sound mode works best on
normal stereo signals. Make sure that the surround
modes on the audio source are switched off when
listening to the HC8905 headphone.
Maintenance – If the headphone will not be used for a long time,
please remove the batteries to prevent leakage and
corrosion.
– Only replace the batteries with LR03/AAA NiMH
batteries (preferably Philips).
– Do not leave the headphone near heat sources. Do
not expose to direct sunlight, excessive dust, moisture,
rain or any kind of mechanical shock.
– Do not use alcohol, thinner or petroleum-based
substances to clean the headphone or transmitter.Use a
slightly dampened chamois cloth to clean the housing.
– Do not use cleaning agents containing alcohol, spirits,
ammonia or abrasives as these may harm the housing.
Hearing Safety! Continuous use at a high volume may permanently
damage your hearing.
XP SBC HC 8900/00-1.1 16-08-2001 15:30 Pagina 11